iPower 16

The bowl trimmer save your half trimming time. Crystal dome to see your product & with inverted cutter blades which are removable from the top. Any project a snap when looking to collect leaves from your plants. Flower trimmer operating instruction: 1. Remove the top from the flower trimmers base remove the top from the flower trimmers base. The inside of the top contains the high-density rubber tongues that are used to push the plant leaves into the blade grill. The cutting blades or wires are located below the grill. 2. Place the untrimmed plants on the grill place the untrimmed plants on top of the grill. The plants should be many to make sure the grill surface is covered(approximately 40 dry). 3. Place the top & handle back on the base Place the top & handle back on the top of the trimmers base. 4. Turn the handle clockwise about 15-30 Rounds using the handle, make 15-30 Complete turns, while spinning the handle, The inside rubber twist tongues multiplies the rate of the spinning plants & blades by over 30 times. A combination of the rubber tongues presses & rolls The plants into the spinning blades can improve the cutting efficiency. Only 30 S can yield one hours work. 5. Remove the top & collect the plant open the top & Trimmed plants & their fragmental bud/leaves can be found individually on the middle grill & in the trimmer basin. Depending on the type of plants, the trimming can be used for the preparation of plants Essential oils. 6. Repeat the process for more harvest if you think the leavepiece are not small enough, keep repeating the Above process as many times as you want, or until you have completed your harvest. When finished, easy clean every part of the trimmer & store it.

Size:16 Trimmer, 2FT 8L, Zippered